What serial protocols does the Anybus Communicator Classic support?
06 Jul 2022
Do I need any additional configuration files to install the Anybus Communicator on the network?
06 Jul 2022
Ewon KPI Setup
06 Jul 2022
Update Netbiter Firmware
06 Jul 2022
KNX IR Compatibility
07 Jul 2022
Can I connect a device using Rockwell “DF1” serial protocol to the Anybus Communicator?
07 Jul 2022
How would I set up the baudrate of a system where Modbus RTU data is read and written by PROFIBUS DP, when my PROFIBUS system is running at 1.5 Mbit/sec and my Modbus RTU is running at 38.4kbit/sec?
07 Jul 2022
Daikin Compatibilities
12 Jul 2022
I need to connect Allen-Bradley SLC controller via DeviceNet to Modbus based field device. Are there some Anybus products that can do this?
12 Jul 2022
The web site of the Anybus Communicator states that the sub-network can "multi-drop to up to 31 nodes". But the Anybus Configuration Manager limits this to 100 “transactions”. Is this a limitation?
12 Jul 2022
What is “termination” and do I really need it?
12 Jul 2022
Why can I not reach the bridge from my PLC application?
12 Jul 2022
What are the default communication ports and protocols used by the bridge on the IT/.NET side?
12 Jul 2022
I am able to establish a connection on both the IT and the OT side of the bridge but I do not get any data through. What could be the reason?
12 Jul 2022
How do I change the transfer rate of the data?
12 Jul 2022
How can I determine from the .NET application if the PLC is configured and running?
12 Jul 2022
I do not get a led indication on the OT led even though my PLC is connected, what could be the problem?
14 Jul 2022
What RAM and ROM resources are needed to be able to use the Host Application Example Code
14 Jul 2022
After powering on the CompactCom, are there any specific LED indications to look for to be sure the module is running?
14 Jul 2022
Are there any specific reason to use the black or the white Anybus Wireless Bolt?
