How to add the Indoor Units to a Intesis Mitsubishi Electric City Multi Systems Gateway

17 Nov 2022

In this article, it will be explained how to configure the Indoor Units for the Mitsubishi Electric City Multi Systems Gateway. 

 

APPLICABLE PRODUCTS 

  • Multi-Unit Gateways (INKNXMIT015C000, INKNXMIT100C000, INMBSMIT050C000, INMBSMIT100C000).

PRE-REQUISITES

To be able to use the mentioned gateways, it is necessary to have a compatible Mitsubishi Centralized Controller. Which are: G-50, GB-50, AB-150, AE-200, EW-50, EB-50.

 

CONFIGURATION

To be able to configure the Indoor Units correctly, we always recommend using the SCAN button in the Intesis MAPS software which can be found under Configuration --> Mitsubishi Electric. It is necessary to configure the gateway IP address within the same range as the Central Controller's IP and put the correct IP address of the Mitsubishi Electric Centralized Controller. 

mceclip0.png

 

The reason behind that is most of the Indoor Units can only be configured via Scan as it is explained in this User manual starting on Page 15 "Mitsubishi Electric Configuration"

 

mceclip0.png

 

ADDITIONAL INFO

To know more about how to use our Intesis MAPS, check our Intesis MAPS eLearning

 
© HMS Networks AB 2022 - Reviewed: Q1/2023