My Fujitsu RC Gateway does not show the correct Ambient Temperature

11 Nov 2022

In this article, we explain how to proceed when the ambient temperature isn't shown when using the Intesis Fujitsu gateway (1-1 RC gateway).

 

APPLICABLE PRODUCTS 

Intesis 1-1 RC Fujitsu Gateway/Device: INKNXFGL001R000, INWFIFGL001R100, INKWMPGL001R000, INMBSFGL001R000.

 

ISSUE

The Fujitsu wired remote control does not read the ambient temperature when using an Intesis 1-1 gateway/device.

 

SOLUTION

You must set the Indoor Unit as follows:

  • Connect the Intesis Gateway/Device to the Indoor Unit and the standard wall controller and start the room temperature sensor on the wall controller.
  • Set the wall controller to send the Ambient Temperature. Detailed information on how to set up
    the wall control can be found in the image below, extracted from the Fujitsu remote controller manual.

blobid0.png

 

© HMS Networks AB 2022 - Reviewed: Q1/2023