RM-232 Setup

RM-232 Setup is used for configuring RemoteTRAK and EtherTRAK I/O Modules. Typically, they have DB9-style connectors for their Serial Port. Here are the steps to configure a RemoteTRAK/EtherTRAK module using an RM-232 Setup.

• Insert the RM-232 Setup into the base of the module being configured.
• Connect the ST-CABLE-PF between the Computer and DB9-SERIAL PORT on the Setup module.
• Open Sixnet I/O Toolkit software. Select Device -> Select -> Use com port and choose the appropriate com port (com1, Com2, etc)
• In the main window, click on the configuration field for the module to be loaded and select Operations -> Load now command. This will write the configuration into base of the module.

Note: You can remove the existing module and insert the field setup module even when power is applied.

Disclaimer

It is the customer's responsibility to review the advice provided herein and its applicability to the system. Red Lion makes no representation about specific knowledge of the customer's system or the specific performance of the system. Red Lion is not responsible for any damage to equipment or connected systems. The use of this document is at your own risk. Red Lion standard product warranty applies.

Red Lion Technical Support

If you have any questions or trouble contact Red Lion Technical Support by clicking here or calling 1-877-432-9908.

For more information: http://www.redlion.net/support/policies-statements/warranty-statement